Hyundai HASE-270 ADSL Router Command Reference

Please note what you can get short syntax reference by typing a command without arguments. However, we discovered what some syntax strings displayed are wrong!

Basic commands

ls	List the commands available on the current level. In the listing (see below) O means the command or level is accessible to the ordinary user, A - to the administrator user only. <LIST> means a sublevel.
exit	Exit to the upper level ar logoff from the router (on home level)
save	Save configuration to NVRAM
reboot	Reboot router
ifconfig -o -a	Show interfaces information

Top (Home) Level

A	<LIST>	qosc	Quality of Service and Firewall (Filter) settings
A	<CMD>	nat	Network Address Translation
O	<CMD>	list	List interfaces (detailed and inconvenient, ifconfig is more useful in mst cases), Routing Table, ARP Table, TCP and UDP connections.
O	<CMD>	statistic	List statistic by protocol (IP, TCP, UDP, ICMP)
O	<CMD>	route	Route Table manipulations
O	<LIST>	sndcp	Router mode setting. PPPOE, PPPOA control.
A	<CMD>	erase	Erase router configuration. Warning: no confirmation will be asked!!!
O	<LIST>	bridge	Bridging setup
A	<LIST>	ethernet	Ethernet interface settings and statistics, speed and duplex control
A	<LIST>	config	Downloading and uploading configuration by TFTP, validity check
A	<LIST>	rarpd	RARP Daemon settings
A	<LIST>	auth	Users and passwords control
A	<LIST>	snmp	SNMP settings
A	<LIST>	atm	ATM layer statistics and settings
O	<LIST>	adsl	ADSL layer statistics and settings

Selected commands

nat -o -status
nat -o -redirect_port udp 192.168.1.2:4672 4672	Port forwarding